Linker Modules and Shields

Allows simple and tidy connection between all Linker sensors or modules and Arduino.

The Linker Rotary Potentiometer Module produces analog output between 0 and Vcc (5V DC with Arduino) on its D1 connector.

This vibration sensor module of Linker Kit uses a spring based sensor.

This buzzer module will generate around the audible 2kHz range.

A capacitive touch sensor to replace a push button

Two momentary push buttons mounted on a single board for Arduino/pcDuino via the Linker connection.

Flame sensor module of Linker kit is only sensitive to the light in the frequency band of infrared and ultrviolet.

This LED bar is a standard Linker kit module, so it can connect to Arduino or pcDuino easily via the base shield.

Connects Linker kit sensors/modules and Linker kit base shield.

Inside the tilt switch is a pair of balls that make contact with the pins when the case is upright.

Linker LED Module is designed for beginners of Arduino/pcDuino to monitor controls from digital ports.

Linker LED Module is designed for beginners of Arduino to monitor controls from digital ports.

The light sensor, also known as the light dependent resistor (LDR)

This hall module hosts an magnetic hall sensor that senses the presence of magnetic field.

The Linker Infrared Receiver Module is used to receive infrared signals and also used for remote control detection.

This sharp distance sensors are a popular choice for many projects that require accurate distance measurements.

Connects Linker kit sensors/modules and Linker kit base shield.

Linker LED Module is designed for beginners of Arduino/pcDuino to monitor controls from digital ports.

Linker LED Module is designed for beginners of Arduino/pcDuino to monitor controls from digital ports.

Linker LED Module is designed for beginners of Arduino/pcDuino to monitor controls from digital ports.